Graphic LCD Display FSTN

Graphic LCD Display FSTN

Number of pixels:96*48
Display type:FSTN , TRANSFLECTIVE,POSITIVE
Built-in controller:ST7549T-G2
Driving method:1/68 DUTY, 1/9 BIAS
Connector type:COG + FPC

Send Inquiry

Product Details

Graphic LCD display FSTN

Description of graphic LCD display FSTN ADG9648A1

Item

Specification

Number of pixels

96*48

Display type:

FSTN , TRANSFLECTIVE,POSITIVE

Built-in controller

ST7549T-G2

Driving method

1/68 DUTY, 1/9 BIAS

power supply

8.6V

Connector type

COG + FPC

Backlight

Blue/2chips


Graphic LCD display FSTN ADG9648A1 is 96*48 dot matrix, COG (Chip on Glass) Graphic LCD Module in FSTN Positive LCD Mode .Graphic LCD display FSTN ADG9648A1 is recommended for applications that will be used both indoor and outdoor. This product is assembled chip on glass with 1/65 Duty and 1/9 Bias. This LCD uses Controller IC ST7549T-G2  .


Outline dimension of graphic LCD display FSTN ADG9648A1

image001.jpg

image002.jpg


FAQ:

What is a resistive touch panel?

A resistive touch panel typically uses a conductive glass backplane with a plastic conductive-
coated inner surface. These conductive inner layers are separated by spacer dots evenly
distributed across the active area. Finger or stylus pressure causes internal electrical contact
at the point of touch, which supplies the touch screen controller with a vertical and horizontal
analog voltage for digitization. The three most common formats are:

Digital – Has a discrete number of touch locations determined by a series of rows and columns
of conductors within the touch panel.

4-wire – Is an analog device that, when combined with the touch screen controller, can identify
any point within the active area of the touch panel.

5-wire – Similar to the 4-wire, but has increased reliability for more extensive use-based
applications.

 

What is a capacitive touch panel?

A capacitive touch screen is constructed out of glass with a coating of capacitive material
electrodeposited over its surface. Oscillator circuits at the corners of the capacitive glass measure
the capacitance of a person touching the glass surface. Each oscillator will vary in frequency
according to where a person touches the surface. The touch screen controller measures the
frequency changes to determine the X and Y coordinates of the touch. The drawback is that
capacitive touch screen cannot be activated by any non-conductive material, including a gloved
finger.

These are three main types:

Surface Capacitive – An exposed ITO conductor on the surface that is touched directly.
Commonly seen in newer household appliances.

Projected Capacitive – Contains two layers of conductors, typically glass. Projected capacitive
has higher accuracy due to the separate scanning of the top and bottom layers. This is the most
common technology used in combination with small format LCD displays.

Single-layer Capacitive – Contains only one layer, with the ITO conductive film underneath
this layer, which is typically glass. Single-layer capacitive has a lower accuracy as the single
conductive layer both emits and receives the signal.

 



Hot Tags: graphic lcd display fstn, China, manufacturers, suppliers, factory, customized
Related Products

Inquiry

  • Your Name:
  • *E-mail:
  • Phone:
  • Company:
  • Title:
  • *Content: