Thin-Film-Transistor LCD Module
Model: XTPW70NP01-03
Screen Size:7.0inches
Display Resolution:800RGB(H)x480(V)
Active Area:154.08 (H) x 85.92 (V)
Outline Dimension:170.08(W) x 103.92(H) x5.525 (D)
Thin-Film-Transistor LCD Module
Model: XTPW70NP01-03
Monitor TFT LCD display
Description of monitor TFT LCD display XTPW70NP01-03
Item | Specification | Unit |
Screen Size | 7.0inches | Diagonal |
Display Resolution | 800RGB(H)x480(V) | Dot |
Active Area | 154.08 (H) x 85.92 (V) | mm |
Outline Dimension | 170.08(W) x 103.92(H) x5.525 (D) | mm |
Display Mode | Normally white/Transmissive | -- |
Pixel Arrangement | RGB-Vertical Stripe | -- |
Display Color | 16.7M | -- |
Gray scale inversion Direction ion | 6 o’clock | |
Viewing Direction | 12 o’clock | -- |
Drive IC | HX8264*1 HX8664*1 or Compatible | -- |
Surface luminance | 300 cd/㎡ | |
TP | 6WIRE -CTP |
1.General Description and Features of monitor TFT LCD display XTPW70NP01-03
Monitor TFT LCD display XTPW70NP01-03 is a 7”TFT for Auto Truck CCTV Surveillance, Remote control, 4 Channels RCA Video inputs. The resolution of this monitor TFT LCD display XTPW70NP01-03 is 800RGB(H)x480(V) .The surface luminance is 300 cd/㎡. It also contains a 6wire CTP.
2 Input Terminal Pin Assignment of monitor TFT LCD display XTPW70NP01-03
3 Optical Characteristics of monitor TFT LCD display XTPW70NP01-03
Touch Controller: | FT5426 |
Touch Panel Vendor ID: | Address: 0xA8 Data:0X03 |
Firmware version number: | Address: 0xA6 Data:0x01 |
3 Reliability Condition for LCD
No change on display and in operation under the following test condition.
Condition: Unless otherwise specified, tests will be conducted under the following condition.
Temperature: 20±5°C Humidity: 65±5%RH
Tests will be not conducted under functioning state.
No. | Parameter | Condition | Notes |
1 | High Temperature Operating | 70°C±2°C, 240hrs (Operation state) | -- |
2 | Low Temperature Operating | -20°C±2°C, 240hrs(Operation state) | -- |
3 | High Temperature Storage | 80°C±2°C, 240hrs | -- |
4 | Low Temperature Storage | -30°C±2°C, 240hrs | -- |
5 | High Temperature and High Humidity Operation Test | 60°C±2°C, 90%, 240hrs | -- |
6 | Vibration Test | Total fixed amplitude: 1.5mm Vibration Frequency: 10~55Hz One cycle 60 seconds to 3 direction of X, Y, Z each 15 minutes. | -- |
7. | Drop Test | To be measured after dropping from 60cm high on the concrete surface in packing state. Concrete Surface | -- |
Notes:
1. No dew condensation to be observed.
2. The function test shall be conducted after 4 hours storage at the normal temperature and humidity after removed from the test chamber.
3. Vibration test will be conducted to the product itself without putting I in a container.
5 Dimensional outlines of monitor TFT LCD display XTPW70NP01-03
FAQ
1.Can I control the backlight brightness ?
CCFL frame rate can be modulated for a small percentage of time at full voltage.This may cause some noise but you can have limited contrail of the CCFL. However LED backlight brightness is easier to control. It can be achieved by regulating the backlight DC-current, PWM control or implementing special LCD driver (IC).
2. How can I reduce the LCD signal noise ?
Noise on an LCD signal can be reduced with a termination resistor and capacitor that can be tuned to the cable characteristics. This will allow you to soften the edges and reduce the noise.
3. Are intialization codes available for Hantronix LCD displays?
The initialization codes can be found in the LCD specification, and or in the controller specification.
4. What is the difference between a digital TFT and a Analog TFT ?
The difference is the interface signal. The digital TFT is designed to accept digital interface signals TTL/LVDS. The analog TFT is designed to accept analog RGB/NTSC/PAL interface signals.