4.3 TFT LCD
4.3 TFT LCD XTPY43SN09-01
Model No. XTPY43SN09-01
►Display Format : 480x272
►Size:.4.3"
4.3 TFT LCD
4.3 TFT LCD XTPY43SN09-01
Model No. XTPY43SN09-01
►Display Format : 480x272
►Size:.4.3"
►View Direction:6H
►Interface: MCU
►Built-in Controller: ST7282T
►Touch Screen : NA
General Description of 4.3 TFT LCD XTPY43SN09-01
4.3 TFT LCD XTPY43SN09-01 is a TM (Transmissive) type color active matrix TFT (Thin Film Transistor) liquid crystal display (LCD) that uses amorphous silicon TFT as a switching device. This 4.3 TFT LCD XTPY43SN09-01 is composed of a TFT-LCD module, a driver circuit and a back-light unit . The following table described the features of XTPY43SN09-01
Features
1.LCD Module
Item | Specification | Unit |
Screen Size | 4.3inches | Diagonal |
Display Resolution | 480RGB(H)x272(V) | Dot |
Active Area | 95.04(H) x53.86 (V) | mm |
Outline Dimension | 105.5(W) x 67.2 (H) x 2.9 (D) | mm |
Display Mode | Normally white/Transmissive | -- |
Pixel Arrangement | RGB-Vertical Stripe | -- |
Display Color | 16.7M | -- |
Gray scale inversion Direction ion | 12 o’clock | |
Viewing Direction | 6 o’clock | -- |
Drive IC | ST7282T | -- |
2.Mechanical Information
Item | Min. | Typ. | Max. | Unit | Note | |
Module Size | Horizontal (H) | -- | 105.5 | -- | mm | -- |
Vertical (V) | -- | 67.2 | -- | mm | (1) | |
Thickness (T) | -- | 2.9 | -- | mm | (2) | |
Weight | -- | N/A | -- | g | -- |
Note (1) Not include FPC.
Refer to the Outline Dimension for further information.
(2) Back-light unit are included.
3.Electrical Specifications
3.1 Absolute Max. Ratings
3.1.1 Absolute Ratings of Environment
If the operating condition exceeds the following absolute maximum ratings, the TFT LCD module may be damaged permanently.
(Ta=25±2°C, VSS=GND=0) | |||||
Item | Symbol | Min. | Max. | Unit | Note |
Storage temperature | TSTG | -30 | 80 | °C | (1) |
Operating temperature | TOPR | -20 | 70 | °C | (1,2,3) |
Note (1) 95 % RH Max. ( 40 °C ≥ Ta ). Maximum wet-bulb temperature at 39 °C or less. (Ta > 40 °C) No condensation.
Note (2) In case of below 0°, the response time of liquid crystal (LC) becomes slower and the color of panel becomes darker than normal one. Level of retardation depends on temperature, because of LC's character
Note (3) Only operation is guarantied at operating temperature. Contrast, response time, another display quality are evaluated at +25°C.
3.2 Electrical Absolute Rating
3.2.1 TFT-LCD Module
(Voltage Referenced to VSS) | |||||
Item | Symbol | Value | Unit | Condition | |
Min. | Max. | ||||
Digital Power Supply Voltage | VDD | VSS-0.3 | 5.0 | V | -- |
3.2.2 Back-Light Unit
Item | Symbol | Value | Unit | Condition | ||
Min. | Typ. | Max. | ||||
LED Voltage | VF | 13.5 | 15.0 | 16.5 | V | |
LED Current | IF | - | 40 | - | mA | |
Power Consumption | PBL | - | 600 | - | mW |
4.Electrical Characteristics
4.1 TFT-LCD Module (DC Characteristics)
5.Input Terminal Pin Assignment
6.Optical Characteristics
7.Interface Timing
8.Reliability Condition for LCD
No change on display and in operation under the following test condition.
Condition: Unless otherwise specified, tests will be conducted under the following condition.
Temperature: 20±5°C Humidity: 65±5%RH
Tests will be not conducted under functioning state.
No. | Parameter | Condition | Notes |
1 | High Temperature Operating | 50°C±2°C, 48hrs (Operation state) | -- |
2 | Low Temperature Operating | -10°C±2°C, 48hrs (Operation state) | -- |
3 | High Temperature Storage | 80°C±2°C, 240hrs | -- |
4 | Low Temperature Storage | -30°C±2°C, 240hrs | -- |
5 | High Temperature and High | 60°C±2°C, 90%, 240hrs | -- |
6 | Vibration Test | Total fixed amplitude: 1.5mm Z each 15 minutes. | -- |
7. | Drop Test | To be measured after dropping from 60cm high on the concrete surface in packing state. | -- |
Notes:
1. No dew condensation to be observed.
2. The function test shall be conducted after 4 hours storage at the normal temperature and humidity after removed from the test chamber.
3. Vibration test will be conducted to the product itself without putting I in a container.
9.Dimensional outlines
FAQ
1. What is the application of 4.3 TFT LCD ?
4.3 Inch TFT LCD Module for Instrumentations, Medical devices, Industrial terminal.
2.Have you got Rohs complaint for your products ?
Answer:Yes, We provide full ROHS& REACH compliant products .
3.Controller ST7282T
ST72-Core Controller/Driver for max. × 4 LCD segments (ST7LCD4) 56 bytes LCD-RAM 864 bytes data RAM 512 bytes EEPROM (eep2a) 32Kbytes program ROM 24 digital I/O (ST7 IO3) with pull up, interrupt input, analog input, push-pull/ open drain output 36 LCD/IO combi pins (ST7 LCIO1) with pull-up, interrupt input, push-pull, open drain output, LCD output 16 bit reload timer (ST7TIM4) Watchdog Timer WD2) 8 bit synchronous serial I/O (ST7SIO) Group & Block Sync Module for RDS (ST7 RDS GB) RDS filter (ST7 RDS FI) LCD Synchro IN / Out System Frequency 8.55 MHz VDDP VSSP VDDA VSSA SE T MPX IL RDS REF 4 /R tio n PORT 2 ST7 LCIO S IO RDS DEM OD. LK ST ilte r ST7 LCIO DS IL